Best Ceramic Fuse For A 32 Inch Lg Tv

Microwave fuse 20 Amp 250V 6×30 mm/0.24×1.2 in(Dia x Len)

Key Remind:

1.shut down power before you replace

2.check your original size of fuse, mainly several parameters, body diameter, body len, rate current, rate voltage

Most Important Point

Question: Why does my microwave fuse offen burnt after I replace fuse not long?

Answer:Microwave fuse should use slow-blow type because its loading will increase much when microwave starts. It needs a little overload when machine starts(only a short time). So some people replace it with fast-acting fuse and cause burnt frequently. Using wrong type fuse.

Question:What type appliances are need slow-blow(time-delay)fuse?

Answer:Normally inductive appliance needs. This type device’s current loading will be much high when it starts, like surge current impact.Common microwave,motor, metal halide light. Yet resistant loading like electrical heating tube is not need.

High Quality Fast Blow Ceramic Fuses Tubes!
Breaking Voltage : 250V;
10 Different Ampere Values: 0.5A, 1A, 2A, 3A, 4A, 5A, 6A, 8A, 10A, 15A
Package Quantity: 100pcs (Each 10pcs)
Dimension : 5 x 20mm/ 0.2″ x 0.8″, Material : Ceramic , Metal

Manual Tile Cutter 32″ Cutting Length Adjustable Laser Guide for Precision Cutting

Manual tile cutter with infrared ray device and special linear bearing block cut parts, this tile cutter features highly accurate cutting and with antiskid rubber handle,which provides better using experience,smooth slide way without obstacle and movable supporting foot for tile protection and uses high quality ball bearing and solid steel rail for improving its stability.Ideal for cutting stone materials including normal floor tiles, polished tiles, etc.

Features:

Infrared ray device for preciser cutting

Antiskid rubber handle of much comfort

Smooth slide way without obstacle

Solid steel rail, stability highly improved

High quality ball bearing

Movable supporting foot for tile protection

Item Specifications:

Max. Cutting Length: 32″ (800mm)

Min. Cutting Width: 1.38″ (35mm)

Cutting Thickness: 0.24″ – 0.6″ (6mm – 15mm)

Steel Slide Rail

Alloy Cutter Wheel

10mm (0.39″) Rubber Sponge Compond Pads

How to Use:

1. Positioning

Adjust scaleplate to expect cutting size. Hold the handle and pull sliding seat towards back seat direction. Place the tile on baseboard and align its cutting line with baseboard beam.

2. Lining

Put down handle to contact flywheel with tile surface, push the handle to draw a continuous straight line on the tile.

3. Cutting

Raise handle and pull backward gently to make lock block settled steadily on the front end of the tile. Push down with adequate force and your tile will be divided apart.

Package Content: